It is best to rinse your BubbleSacs with clean cold water after each use this will keep them cleaner for longer.

When the BubbleSacs become clogged with sticky hash dry them and crumble as much of the hash as possible, then clean the mesh with pure alcohol. This will remove all traces of hash.  Finally rinse of the alcohol with clean cold water.
This process will leave your BubbleSacs as good as new.

Wrap the collected resin glands in pressing cellophane and place in a snap lock baggie. Then place in another baggie to ensure no water enters the resin parcel.
 
Submerge in a large pan of boiling water for 2 – 3 minutes until the resin parcel feels soft and pliable (the time will vary depending on thickness of plastic bag used and the amount of resin glands being pressed). 

Remove the bag carefully as not to burn yourself and apply pressure (for example, place on a flat surface put a telephone book on top of the packet then stand on the telephone book to press) once pressure has been applied remove from bag and place in the freezer for a few minutes to cool down. Once the hash has cooled and hardened it is ready to smoke. 

This method is for high-grade water hash. Dry sieved hash will require a little more heat and pressure.

Use the BubbleScreen to re-sieve dry hash to improve quality.

Select sieving dry hash by removing the last 10% of hash from each re-sieving will yield a much higher grade dry hash.

Use the Honeybee to process any lower grades you do not enjoy smoking.

Make honey oil from low-grade water hash (from the n.o4 sac for instance). Process waste re-sieve from the BubbleScreen.

Cooking is a good way to supply cannabis to a medical user.  Start with a small amount of low-grade increase dose and grade to suit patient until satisfactory results are achieved.

Mix honey oil with CatchingSac hash to make it bubble and improve strength and quality.

…a Hash maker’s best friend. Pressing cellophane can be used to press extracted crystals into hash.  Pressing glands using heat and pressure turns them into Hash. Hash is more psychoactive and has a better flavour than un-pressed crystals. Once pressed Hash will last much longer with less deterioration in potency and flavour.

When using cellophane to press hash make a parcel for your hash in the size and shape you want your hash.

If you lick an edge of cellophane it will stick to its self like an envelope.

When making a cellophane parcel make sure there is enough room for the hash to expand when pressed if the parcel is wrapped to tightly it will burst under the pressure of pressing.

After you have collected your resin glands in the BubbleSacs be sure to rinse clean cold water through your hash to clean any green plant particles out of it before drying.

Dry glands will make a far superior smoke, allow at least five days to dry before bonding into hash. Once dry applying heat and pressure will bond the glands into hash, with higher grades this can be done by just rolling and pressing the glands in your hands.

Alternatively, wrap the glands in a cellophane packet and place in the sole of your shoe. Walking around will create enough heat and pressure to bond a solid piece of hash.